Talaria Battery 72v 4464Wh 62Ah ATOM V2 25Kw

Talaria Battery 72v 4464Wh 62Ah ATOM V2
High Power, Mega Long Range 25Kw
(74.5Ah Equivalent @ OEM 60V)
ASI, EBMX, VTB, Torp, KO & Nucular Controllers Compatible
up to 18Kw – 700Phase
Tough Protective 316 Stainless Steel Case
Fully Protected BMS
Single Discharge Connector
Power: Very High (25Kw)
Range: Ultimate High (4464Kwh 297% Over OEM)
Height: Tall (387mm – Seat lift kit recommended)
Battery Activation Required On Delivery
On delivery, please send us a request to have your battery activated.
This will also be regarded as confirmation that your battery has been received.
Choice of colours, just state in check out message: Yellow, Blue, Purple or Red.
Talaria Battery 72v 4464Wh 62Ah High Power, Mega Long Range ATOM 25KW
Talaria Battery 72v 4464Wh 62Ah ATOM V2 25Kwbattery and was primarily designed for high power and HUGE long range.  With a powerful aftermarket controller (see our controllers page) the set up for this battery will be 15-18Kw, depending on your motor.  Please observe the specifications for your controller and motor.  Exceeding the recommended limited may invalidate your warranty.
Exoskeleton /Casing
We have upgraded the casing to marine grade 316 stainless steel, so absolutely no rust issues here! Super tough and powder coated inside and out.
Connectors
The main battery to controller connectors we use are the same type as used by Talaria to keep everything compatible. This allows you to swap your standard battery back should you wish.
Domestic Electrics
All your bike accessories are still powered. Some believe that not using the circuit breaker direct to the controller removes the safety of the circuit breaker. However, all our batteries have a full working BMS. Any power shorts or irregular current and the BMS shuts down.  This is much more sensitive and accurate than a mechanical breaker (you may note that the Sur Ron Ultra Bee does not use a circuit breaker and relies on the BMS alone).
Battery Compartment Lids or Lifting Kits
Because of the extra battery height (385mm) minor modification will needed to your bike. Remove the battery compartment tray
There are several options:
#1
Fit an aftermarket battery compartment lid
– there are several on the market
#2
Remove the battery plastic base tray
in the bike (simply remove the 5 small allen key bolts from the top looking down) and fit our 5mm spacer between the metal battery lid catch and the lid (spacers provided)
#3
Seat Lift Kit option:
https://www.electroncycles.co.uk/product/talaria-mx-seat-lift-kit-black-full-e-charged/
Specifications for Talaria Battery
SKI 62Ah
20s Battery
Nominal Voltage: 72V
HVC: 84V
LVC: 59V
DC line 220A burst 350 (Setting over 220A may cause the BMS to trip if throttle held wide open for too long)
Max Power rating (Discharge): 18,000 Watts
Max Phase Amps: 700A
Height 387mm
Weight 19KG
1 x Air Wedge
BMS monitoring individual series condition with balanced charging.
An integrated cord handle for lowering the battery in and out.
Connecting To Bike
When connecting the battery to the bike and to avoid a spark, turn the red trip switch on the bike to off. Connect the older original power cable and then turn the red trip to on. Then connect the new power leads. Removing the battery has no special order.
Battery Charging
First time charging is VERY important. Always connect the charger to the battery with the charger powered up at the mains first. This will stop a “Connection Spark”. The battery needs a “Balance Charge” on first charge. Please charge for 12 hours first time.  Always charge your battery in a safe place and never unsupervised.
Charger NOT Included
Our recommended charger for this battery is:
https://electroncycles.com/product-category/batteries-chargers/72v-20s/page/3/
This Battery will not work with an original standard Sur Ron Controller